Replacing the display of the IPC
 |
This document describes how to replace the display of the IPC of your system. |
1. Use following tools
|
|
|
2. Procedure
Disconnect the power supply cableto the IPC (disconnect the power cable).Disconnect from all sources and poles.
Remove the IPC from the control cabinet.
Place the IPC on a clean, flat surface.
Remove the 6 Torx screws marked with a little arrow.
The IPC can now be lifted up from the display.
To reinstall the IPC on a diffrent display, follow these steps in reverse.
3. How to get further help
Do not hesitate to contact us when you need additional support beyond the documents provided in the RoboJob Service Knowledge Base.
You may contact the RoboJob Service department using following means:
-
Help Center: service.robojob.eu
-
Email: service@robojob.eu
-
Phone: +32 15 70 89 70
We kindly ask you to provide us the following information:
-
Serial number xx-xx-xxx
-
Description of the fault or defective part
-
Exact error code or message
-
What did the robot do
-
What was the robot supposed to do
-
Pictures or videos
You can send this information to us via email.To send large files you may make use of a file transfer service like WeTransfer: robojob.wetransfer.com.
An automatic confirmation will be sent upon receipt of your mail.