Start a conversation Sign in
Start a conversation
  1. RoboJob
  2. Hardware
  3. Generation 1
Note

This document describes how to move the stacker tables by hand.This is necessary when the stacker tables reached a software limit, preventing it from moving.

1. Use following tools

stacker Gen1 mech drawnFront
RoboJob stacker table

tools Hex keys
Hex keys

tools spanner
Spanner

2. Procedure

2.1. Power of the system

Power of the system using the main switch.

2.2. Remove the front cover

Remove the upper part of the front by holding the handholds on the side and tilting upwards.

stacker Gen1 mech table frontRemoved
Figure 1. stacker with front removed

Loosen the hex screws holding the front cover in place and slide it upwards.You can then pull the cover off.

stacker Gen1 mech table front mountingHoles
Figure 2. Cover mounting holes

2.3. Manually move the table

Turn the spindles using the hex nut on the bottom.Moving the tables by a few centimeters should be sufficient.

stacker Gen1 mech table spindles moveManually
Figure 3. manually turning the spindle

3. How to get further help

Do not hesitate to contact us when you need additional support beyond the documents provided in the RoboJob Service Knowledge Base.

You may contact the RoboJob Service department using following means:

We kindly ask you to provide us the following information:

  • Serial number xx-xx-xxx

  • Description of the fault or defective part

  • Exact error code or message

  • What did the robot do

  • What was the robot supposed to do

  • Pictures or videos

You can send this information to us via email.To send large files you may make use of a file transfer service like WeTransfer: robojob.wetransfer.com.

An automatic confirmation will be sent upon receipt of your mail.

Choose files or drag and drop files
Was this article helpful?
Yes
No